KozMos AnnoRay

  Build lines from base point to indicate certain annotations
กก         It may be a very easy way to know the number of certain annotations (normal texts or attributes nested in blocks), but it may be little difficult to fine the position of all these annotations. In some situations, we do have the require to know the real location of the annotations in order to process further operations. What we can do in such a situation? Re-memorize our mind to think about the possible positions or select all of them and process a temporary move to bring us a clue?
        The answer is NO! KozMos freeware AnnoRay will do this for you. A line from a pre-defined base point to the center of the annotation will be created in order to lead us to the location of annotation(s) directly.

        KozMos AnnoRay supports searching annotation by wild-char match and full word match (case sensitive in all match modes). The color of created line can also be set within the dialog.

        To start AnnoRay, just type ANNORAY at AutoCAD "Command:" prompt.

Dialog Interface

        Once the program is lunched, all available attributes and texts will in current drawing will be gathered in proper content lists. if no attribute or text is found, *< NONE >* will display in the list. If *< NONE >* is selected as match content, it will be ignored.
        The toggle switch of attributes and texts are effective to all match modes. But the content list will only be valid for full match. In current version, multiple contents are not supported.
        Contents can be done by picking exist attribute or text from graphic screen. Only annotations in current layout (Model or Layout-n) will be valid for this product.

        The base point can be re-defined by picking a point on graphic screen, or UCS (0.0, 0.0) will be use as default.

        Line color can be set within the dialog as well, and true color is also supported.

        All lines created can be gathered into an unnamed block in order to simply the operation selecting them.

        AnnoRay support scanning all drawing data or just selected object(s) to create the lines.
กก

Program record

  • 2006-04-20
    Support true color in AutoCAD2007
    Limitation on layout
    Pick contents from graphic screen
  • 2006-03-31
    1st release codes done
กก

//Koz Jono Yeoh//

Copyright(C) 1994-2009 KozMos Inc
All rights reserved.